A false start is a runner leaving before the gun, on a gun that really fired. The race has to be run again, and nothing timed on the first try can count. False start does both in one action: it stops every device on that heat, throws away what they captured, and puts the same heat back on the line.
Who can recall a start
- The starter, from the running heat on the Starter screen, and staging, from the running heat's card. When a starter or staging device is covering the heat, the recall is theirs.
- A finish timer, on a heat with no starter. When the finish crew starts the heat themselves, every finish device that tapped Start can recall it, as long as the heat is still running and that device hasn't recorded its own finish yet. A device that didn't tap Start isn't offered the button.
Recalling, and why it takes a hold
The False start button sits at the top of the screen, away from the controls you use at speed. On a finish timer it is above the big Stop button, so reaching it is a deliberate move.
A recall throws away a real race if it is pressed by mistake, so it is built to be hard to trigger:
- A plain tap does nothing except show "Hold to recall".
- Hold it for about a second. A ring fills around the flag.
- Confirm. The confirmation says what will happen: every seat stops, the same heat goes back to the line, and how many results already recorded will be discarded. Keep running is the safe answer; Recall goes ahead.
Let go before the ring fills and nothing happens.

What happens on every device
- Every timer stops and drops what it captured for the false start, including a time someone had already stopped. A photo finish capture that was open closes without sending its strip.
- Nothing from the false start is saved. If a device was offline and tries to send a result later, it is turned away.
- The same heat comes back to the line with the same lineup, as a fresh run that hasn't been fired.
- Every finish timer taps Ready again. Each one sees "False start. The heat is coming back to the line. Tap Ready when you're set." A fresh Ready from every seat is how the starter knows the whole crew saw the recall.

If two finish timers recall the same start within a second of each other, they still produce one re-run, not two.
Charging the lane that false-started
Whether a false start costs the runner anything depends on your rules, so it is a setting per meet. Find it in Setup › Timing settings, under Starting Line, as Charge false starts:
| Setting | What a charge does |
|---|---|
| Not tracked (the default) | Nothing. Recalls never ask who false-started. |
| Disqualify on the first | The charged lane is disqualified. |
| Warn, then disqualify | The first charge is a warning; a second charge to the same lane in the same race disqualifies it. |
The setting belongs to the meet, so every device on the crew follows the same rule.

When the meet tracks false starts and the heat has lanes, the confirmation asks "Who false-started?" with a checkbox for each lane. Tick the lane or lanes, or tick none: "No one charged" is the right answer for a recall caused by a gun fault, a disturbance, or anything else that isn't a runner's fault. Pack and distance heats are recalled without charging.
Charges count within one race only. A warning carries across that race's re-runs, so a lane warned on the first recall is disqualified if it is charged again on the second. Nothing carries into the next race.
Step by step: the two ways a recall goes
Every recall starts the same way: hold False start for about a second, then answer the confirmation. What you tick there decides which of these two paths the heat takes.
Everyone re-runs (no one charged)
Use this for a gun fault, a disturbance, a runner who slipped, or any meet that doesn't track false starts.
- Hold False start until the ring fills.
- If the confirmation asks "Who false-started?", leave every lane unticked. It reads "No one charged." (A meet set to Not tracked doesn't ask, and every recall takes this path.)
- Tap Recall.
- Every finish timer shows the false-start notice and goes back to Ready. Each one taps Ready again.
- The starter brings the heat back to the line and fires it as usual. Every lane runs and is timed.
If an earlier recall in the same race warned a lane, that warning still stands. Recalling with no one charged doesn't add to it.
A lane is charged (warned or disqualified)
Use this when a runner left early and your meet is set to Disqualify on the first or Warn, then disqualify.
- Hold False start until the ring fills.
- Under "Who false-started?", tick the lane (or lanes) that left early. The line below the list confirms it, for example "Charging lane 3."
- Tap Recall.
- What the charge costs follows the meet's rule:
- A warning (the first charge under Warn, then disqualify): the lane runs the re-run as normal. The start line and record keeper show "Lane 3 warned".
- A disqualification (any charge under Disqualify on the first, or a second charge to the same lane in the same race under Warn, then disqualify): the lane is recorded as DQ right away.
- Every finish timer taps Ready again, except a disqualified lane's. Its Ready button is disabled and it isn't timed in the re-run.
- The starter brings the heat back to the line and fires it. Every other lane runs and is timed as usual.
The device that recalled the start writes the DQ, so nobody has to enter it by hand. It already carries the athlete's bib.
What a disqualification looks like
On the start line, the heat on deck shows the race's standing above its lanes, here "Lane 4 warned · Lane 3 disqualified". The record keeper shows the same line.

On the disqualified lane's finish timer, Ready is disabled and reads "Lane 3 disqualified, false start", and the notice says the lane won't be timed in the re-run.

On the record keeper, the lane's result is DQ, with the athlete's bib, and it shows as DQ in results. Each false start leaves a "Recalled start" line under the heat with the time of its gun, so the history is there if an official asks later.

Undoing a charge
If a lane was charged by mistake, the record keeper corrects it like any other result: open the lane, and change its status from DQ to Pending (or to a time, once the lane has run). The lane's finish timer gets its Ready button back, and the lane comes off the disqualified list.
What a recall is not
- Not the cancel window. When automatic gun detection hears something, it holds the start for a few seconds so the starter can cancel a detection that wasn't the gun. That is rejecting a sound. A false start is a real gun and a runner who left early. See the starter.
- Not cancelling a heat. A heat that hasn't fired yet is canceled, not recalled. Recall is only for a heat that is already running.
Did this answer your question? If something here is wrong, missing, or out of date, tell us at support@finishlinetimer.com and we’ll fix it.